INSTALLATION GUIDE
IP-DECT Base Station and IP-DECT Gateway
2.3.1
Overview
Figure 4. Overview of the IPBL
lan
synchr
oni
zation
refer
ence
1
2
ring
in
ring out
in
out
base s
tation
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
006
1 2
3
4
5
6
Pos.
Name
Function
1
Reset
Resets the IPBL. For information on how to use the reset button, see
the applicable Installation and Operation Manual for the IPBL.
2
Status LED
Indicates the status on the IPBL.
3
Lan
10BASE-T/100BASE-T Ethernet interface.
LAN1 port must be used in the IP-DECT system (LAN2 port is for
administration only).
Note: This is not applicable when RSTP is used. For information about
RSTP, see the applicable Installation and Operation Manual for the
device.
4
Synchronization
Sync ring in and sync ring out interfaces.
5
Reference
Reference sync in and reference sync out interfaces.
6
Base station 01-16
ISDN U
PN
DECT base station interfaces.
2.3.2
Power Supply
The power supply are located at the rear of the IPBL. The IPBL can be powered using the following
alternatives:
• 110/230 VAC (only IPBL IP-DECT Gateway VAC/VDC)
• 48 VDC
For more information, see
.
Software
The software in the IPBL can be updated by downloading new software without disconnecting the
equipment. The new software is stored in flash memory. For information on how to update the software in
the IPBL, see the applicable Installation and Operation Manual for the IPBL.
2.3.3
LED indication
Status LED
Description
Not lit
Not powered, status is not defined.
Flashing slow green
When pressing the reset button.
TD 92989EN / 25 January 2021 / Ver. E
8
