TD 92989EN
15 October 2014 / Ver. B
Installation Guide
IP-DECT Base Station & IP-DECT Gateway
3
Power Distribution
The IPBS1 can be powered using the following methods:
• Power over Ethernet, IEEE 802.3af
• A local AC-adapter
NOTE: For more information about power distribution, see
3.3
Power the Base Station
on
page 25.
Software
The software in the IPBS1 can be updated by downloading new software without
disconnecting the equipment. The new software is stored in flash memory. For
information on how to update the software in the IPBS1, see the applicable Installation
and Operation Manual for the IPBS1.
Connectors
• Two 8-pin RJ45 modular jacks for LAN/PoE and powering
• A 6-pin RJ12 modular jack for factory testing
LEDs
Status of LED1 (lower LED)
Description
Steady Green
Operational
Flashing fast amber
Download of firmware in progress.
Steady Amber
TFTP mode
Alternating red/green
No Ethernet connection
Status of LED2 (upper LED)
Description
Not lit
IPBS1 operational and no traffic on the IPBS1.
Steady green
IPBS1 operational and traffic on the IPBS1.
Flashing slow green
Fully occupied with traffic.
Flashing red
No air synchronization - searching for air sync
candidates.
Flashing fast red
Download of RFP software in progress.
Alternating red/green
RFP not initialized.
