I&M No.V5744-Sec.1
50 Hanover Road, Florham Park, New Jersey 07932 www.ascovalve.com
Page 4 of 4 (Section 1 of 2)
6. Install bonnet gasket and manual operator body with preassembled
parts into valve body. Torque manual operator body to 175 ± 25
in-lbs [19,8 ± 2,8 Nm].
7. Replace solenoid base gasket and solenoid base sub-assembly.
Torque solenoid base sub-assembly to 175 ± 25 in-lbs
[19,8 ± 2,8 Nm].
8. For further reassembly, refer to
Valve Reassembly
step 5.
ORDERING INFORMATION
FOR ASCO REBUILD KITS
Parts marked with an asterisk (*) in the exploded view are supplied in Rebuild
Kits. When Ordering Rebuild Kits for ASCO valves, order the Rebuild Kit
number stamped on the valve nameplate. If the number of the kit is not
visible, order by indicating the number of kits required, and the Catalog
Number and Serial Number of the valve(s) for which they are intended.
solenoid base
solenoid base
stem retainer
gasket
sub-assembly
core assembly
bonnet gasket
stem gasket
stem/spacer
sub-assembly
manual operator
body
with core spring
valve seat
Captive spacer on
stem/spacer sub-assembly
must be located on the
outside
of stem retainer
when reassembled
IMPORTANT
To engage, turn lever
clockwise until it hits a
stop
Partial view of
Manual Operator
AC & DC Construction
AC & DC Construction
Figure 2B. Manual Operator
Indicates that these
parts are included
in Rebuild Kit
Figure 2A
stem retainer
spacer
stem/spacer
sub-assembly
core guide
Partial cutaway view
showing positioning
of core guide and
core spring on core
assembly
IMPORTANT
core assembly
core guide
core spring
