© 2020 ASCO Power Technologies. All Rights Reserved
4
IO-75024
01/2020
For access to self-service tools and chat support visit se.com/us/en/work/support or call 1-888-778-2733 for technical assistance
Model 159
Installation
1.
Turn off all power supplying this equipment before working on or inside
-
equipment.
2. Mount device as close to protected equipment as possible using mount-
ing flanges (hardware not supplied).
3.
Strip all wires going to the field and protected terminal plugs on the
device 0.28 - 0.31 inches.
4.
Connect power wire from field side to the field side terminal on device
marked “VS+” and “GND” for the ground.
5.
Connect data wiring from field to the field side of device marked
“SDIO+” and “SDIO-”.
6.
Connect video wire from field to the field side of device marked “Video+”
and “Video-”.
7. Connect protected equipment wiring to all corresponding terminal on the
protected side of the device.
8. Replace the barrier, cover/door and/or trim to the equipment.
9. Equipment may be re-energized after all the above steps are complete.
Figure 1:
Wiring Diagram
Model 159 (Edco HVCP-48)
Surge Protective Device (SPD)
