SAT-IF CWDM Optical Transmitter and Receiver
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 4 of 13
Warning
Invisible laser radiation is emitted from the end of fiber or connector. Avoid direct exposure to
beam.
Aerial System Earth Connection
The equipment must be connected to the ground electrode of the antenna installation.
Safety Warnings
The product must be installed by a qualified engineer, according to the
local safety standards and regulations.
Caution
The equipment works on optical transmission network system in high power non- visible light
source. Keep people away from source to avoid burning skin and damage on eyes.
Only trained and authorized personnel can open the product. In case of failure, do not try to
repair the product.
Installation Warnings
1.
When installing with transmitter make sure that all power is switched off. Only using the original
power cable (adaptor) supplied and installing the products so that the mains plug is easily
accessible.
2.
To fix the product to the wall use suitable expansion bolts and be easy to connect optical cable,
coaxial cable and power cable. Keeping sufficient spaces for fiber cable to avoid excessive bending
radius of fiber cable, resulting in excessive optical loss.
3.
The products must not be exposed to dripping or splashing liquids and so must be installed
indoors in a dry place. Don't install the product above or close to heat sources.
4.
Humidity and condensation could damage the products. In case of condensation, wait until the
product is dry before using it.
5.
Put on cap on optical connector when equipment not to be used to avoid physical damage.
6.
Clean the optical connector with high purity alcohol for the first time and long-time preservation.
Waiting for the alcohol to evaporate, otherwise cause pollution of the equipment fiber optic
interface, resulting in excessive optical loss.
