AP201CW GPON 1 GE + WiFi ONT
Solutions Provider for FTTx, RFoG and HFC www.ascentcomtec.com
Page 10 of 26
Blinking: Data is being transmitted through the
Ethernet port
Off: Ethernet connection is not set up
3
LOS
GPON optical signals
On: Optical power lower than receiver sensitivity
Off: Optical in normal
4
PON
ONT Register
On: Success to register to OLT
Blinking: In process of registering to OLT
Off: In process of registering to OLT
5
PWR
Power Status
On: The ONU is power on
Off: The ONU is Power off
Connect the fiber: Insert the SC fiber connector into the PON connector on the rear panel of the
ONU.
Connect the Ethernet cable: Connect the RJ-45 Ethernet cable to any LAN (LAN1-LAN4) port and
each home device, that is, the computer, IPTV set-top box, and so on.
Connect coaxial cable: Connect the coaxial cable to the RF connector of the ONU.
Connect the AC adapter: Plug the AC / DC adapter into the AC wall jack and the ONU 12V DC
power jack.
The computer’s local network port IP address manually set to 192.168.101.100, use the
network cable, connect the computer and any one of the Ethernet port of EPON home
gateway ONU, open the IE Web browser, copy and paste URL:
http: //192.168.101.1
, the
following pop-up Prompt landing page: