Asaş Alüminyum San.veTic.A.Ş.
Rüzgarlıbahçe Asaş İş Merkezi 34810
Kavacık / Beykoz – İstanbul/ Turkey
TEL : +90 (216) 680 07 70(PBX)FAX : +90 (216) 680 07 72
Web:
10
1.
Code learning:
a) Connect the receiver as the wires connect way above. Switch on the power, then the motor will
vibrate. Which means it is ready to be programmed.
b) Short-press the learning button once within 10s, the motor will vibrate again. The code learning
is successful.
2.
Copy a new emitter
Emitter F1 has already learned
a) Short-press F1 8 times, the motor will vibrate which means it’s ready to accept the signal of new
emitters.
b) Short-press the learning button of the new emitter F2 once within 10s, the motor will vibrate
which means you have successfully copied the new emitter F2.
3.
Code cleaning
a) First press the stop button to make the motor in stop state, then short-press the learning button 6
times
b)Short-press the up button once, the motor will vibrate, The code clearning is successful.
once
F2
F1
8 times
once
6 times
once