copper pattern. Solder the overlapped area and clip off any excess jumper wire.
At
At
At
At Other
Other
Other
Other Connections
Connections
Connections
Connections
Use the following technique to repair the defective copper patternat connections other than IC Pins. This technique involves the
nstallation of a jumper wire on the component side of the circuit board.
1. Remove the defective copper pattern with a sharp knife. Remove at least 1/4 inch of copper, to ensure that a hazardous
condition will not exist if the jumper wire opens.
2. Trace along the copper pattern from both sides of the pattern break and locate the nearest component that is directly
connected to the affected copper pattern.
3. Connect insulated 20-gauge jumper wire from the lead of the nearest component on one side of the pattern break to the lead
of the nearest component on the other side. Carefully crimp and solder the connections.
CAUTION
CAUTION
CAUTION
CAUTION
: Be sure the insulated jumper wire is dressed so the it does not touch components or sharp edges.
SPECIFICATION
SPECIFICATION
SPECIFICATION
SPECIFICATION
NOTE
NOTE
NOTE
NOTE
: Specifications and others are subject to change without notice for improvement.
1. Application range
This specification is applied to the LED TV used AS-MST6M182VG-LE2 chassis.
2. Requirement for Test
Each part is tested as below without special appointment.
1) Temperature :
25
±
5
º
C (77
±
9
º
F), CST : 40
±
5
º
C
2) Relative Humidity :
65
±
10%
3) Power Voltage : Standard input voltage(100-240V~, 50/60Hz)
* Standard Voltage of each products is marked by models.
4) Specification and performance of each parts are followed each drawing and specification by part number in accordance with
BOM.
5) The receiver must be operated for about 20 minutes prior to the adjustment.
3. Test method
1) Performance: LGE TV test method followed
2) Demanded other specification
- Safety: CB specification
- EMC: CISPR 13 specification
4.
4.
4.
4. General
General
General
General specification
specification
specification
specification
Item
Specification
Remark
Broadcasting system
PAL-BG
Available Channel
1) VHF : 00 ~ 12
2) UHF : 20 ~ 75
3) CATV : 02 ~ 44
Tuner IF
1) PAL : 38.90MHz(Picture)
34.40MHz(Sound)
Input Voltage
100 - 240V~, 50/60Hz
Mark : 240V, 50Hz
Screen Size
21.6 inch Wide (1366 x 768)
LC216EXN-SCA1
Aspect Ratio
16:9
Module
LC216EXN-SCA1
LC216EXN-SCA1
Operating Environment
1) Temp
:
0 ~ 40 deg
2) Humidity :
~ 80 %
LGE Spec
Storage Environment
1) Temp
: -20 ~ 60 deg
2) Humidity :
~ 85 %
