Asada 380SP, Instruction Manual, Page: 17 / 24

PIPE SAW 380SP
16
⑤ Rotate the operating handle counterclockwise and cut the
pipe slowly.
Rotate the handle with the force that does not decrease
the stroke speed．
When the motor gets a heavy load during the operation,
an over-load protector works and the motor automatically
stops. In that case, unlock the switch and wait until the
motor cools down.
⑥ Use the cutting oil depending on the material of pipe.
⑦ The extent of oblique cut will be reduced by using a blade and Guide Plate for 200A in case of
cutting pipes less than 6".
⑧ When cutting is complete, switch OFF, rotate the handle clockwise and unplug.
⑨ Wait a short time after cutting, remove the components in the order of
[Guide plate] → [Saw blade] → [Main body] → [Vise]
Material of pipe Cutting oil（use or not）
Steel pipe
Use
Stainless steel pipe
Cast Iron（Ductile）pipe
Not use mortar lining casting pipe
Resin pipe
◆ Be sure to use the threading oil white（No. ST014）as the cutting oil.
Do not use other cutting oil．
◆ Cutting oil contacting the skin may cause inflammation.
Wear protective gloves when handling the cutting oil. In case it contacts your hands, completely
wash it off with water and soap.
◆ Wipe off the scattered cutting oil after cutting with oil.
The floor may be slippery by cutting oil, causing a fall down.
◆ Do not inhale oil mist or vapor of the cutting oil．It cause nausea．
If inhaled accidentally, move to a place where fresh air prevails. Cover the body to keep warm, lie
quietly and consult a doctor．
◆ Do not handle or use the cutting oil near a fire．
Operating handle
Rotate slowly
5
CAUTION