Up2Stream Mini v2 is a WiFi preamplifier board that can be installed in your existing regular speakers or amplifier to make them wireless
enabled, and it is also a all-in-one solution for DIYers to make their customized wireless audio player. After connecting the device to your
home network, with our 4STREAM APP, you can play music from your home NAS, cell phone memory or from online streaming services like
Spotify, Deezer, Tidal, Qobuz and so on. The wireless multiroom audio system can play the same music to each room in sync or play different
music to different rooms.
1. Introduction
2. Dimensions
3. Interface
B
PH2.0-4P
: LED connector.
LEDs are common-anode connected, to add external LED, you should connect 3.3V to a current limit resister and then to a LED and then to
the pin. (reference the diagram below)
C
IIS:PH2.0-5P:
DOUT,BCLK,LRCK,MCLK,GND.
This is the IIS output port, the BCLK is 2.8MHz, the LRCK is 44.1KHz, the MCLK is 11.288MHz, the DOUT following the standard IIS data
format and have 16 bits depth. The system is running in master mode, you should make sure the IIS port of connected device is running in
slave mode.
D
PH2.0-4P
: ROUT, GND, LOUT, WPS.
For analog output to amplifier board, it has same signal with the 3.5mm Aux jack.
WPS pin is used for external WiFi reset button, you should connect this pin to a switch button and then to GND, to implement function that the
pin will short to GND when pressed button.
4. Specification
Installation notes
External LED connector
B
C
D
E
H
G
I
J
F
5V/1A Mircro USB input
5V-1A DC input connector
WiFi Reset
IR receiver
WiFi antenna
Line-Out, WiFi Reset
3.5mm Line-out
IIS output
B
D
C
F
I
H
G
J
E
Connectivity
Wireless network EEE802.11 b/g/n 2.4G
USB Host
Play USB music
Power Input *
5V-1A/2 pin connector
5V-1A micro USB input
Audio output
Analog 3.5mm/4 pin connector
Digital IIS
Frequency response
20Hz to 20kHz
SNR
91dB
THD
0.03%
Music Format
FLAC/MP3/AAC/AAC+/ALAC/APE/WAV
Decoding
Up to 24bit/192kHz
Protocols
AirPlay, DLNA, UPnP, Spotify Connect, Qplay
Dimensions
55*42mm
* Warning: Up2Stream Mini v2 must use 5V-1A DC input, higher power
supply may damage the board.
LED
: White LED showing system state. Fast blinking for system booting, slow blinking for connecting to network, and lighting on for normal.
WiFi Reset
: Short press to reset the device WiFi, long press to restore the device to factory setting (only works in WiFi mode).
Up2Stream Mini v2 User Manual
Up2Stream Mini v2
