Multi Q Owner's Manual v 1.8 CE ©2003 ARX®
Multi Q Owner's Manual v 1.8 CE ©2003 ARX®
2
7
Multi Q Specifications
Filter Type
Full Parametric State Variable
Maximum Cut/Boost
±18 dB, user variable
Bandwidth
3 octaves to 1/20th octave, user variable Input
Impedance
Balanced 20 Kohms
Unbalanced 10 Kohms
Input Headroom
+ 21 dB
CMRR
>60 dB, 20 Hz - 20 KHz
Output Impedance
Balanced 300 ohms
Unbalanced 150 ohms
Output Level (Max)
+ 21 dB
Frequency Response
10 Hz to 20 KHz, ± 0 .5 dB
Signal to Noise ratio
One Channel:
-98 dB Unweighted
-101 dB ‘A’ weighted
Six Channels:
-88 dB Unweighted
-93 dB ‘A’ weighted
Distortion
.004% THD @ 0 dB,1KHz
Dynamic Range
119 dB (single Channel)
Power Requirements
100-120 V AC, 220-240 V AC 50-60 Hz
8 Watts (8 VA)
Weight
5 lbs/2.2Kg
Dimensions
19"W x 1¾"H x 6"D
482 x 44 x 155mm
Input Connector type
Balanced Jack (TRS)
Output Connector type
Balanced Jack (TRS)
This symbol indicates that a Slow Blow fuse is used in this equipment.
Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated
dangerous voltage within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important operating
instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
WARNING SYMBOLS USED ON THIS EQUIPMENT
WARNING SYMBOLS USED ON THIS EQUIPMENT
WARNING SYMBOLS USED ON THIS EQUIPMENT
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORT
IMPORT
IMPORT
IMPORT
IMPORTANT
ANT
ANT
ANT
ANT
- PLEASE READ THIS FIRST
- PLEASE READ THIS FIRST
- PLEASE READ THIS FIRST
- PLEASE READ THIS FIRST
- PLEASE READ THIS FIRST
This is a dual voltage unit. It is essential that you check that the voltage on the
fuseholder cover below the AC connector on the rear of the chassis is set correctly
before connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert power
cable into unit until voltage has been correctly set. Do not plug power cable into AC
power until voltage has been correctly set
THIS IS SET FOR
100 V AC TO 120 V
AC OPERATION
THIS IS SET FOR
220 V AC TO 240 V
AC OPERATION
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC; CE 73/
23/EEC Low Voltage directive and meets the
following standards: EN 55013 : 1990, Sections
3.2 and 3.5 EN 55020 : 1988, Sections 4.3, 5.4,
6.2, 7.0, 8.0. Complies with Australian Standard
AS/N25 1053
