Graphic Equalizer Owner's Manual v 2.3CE ©1997 ARX®
Graphic Equalizer Owner's Manual v 2.3CE ©1997 ARX®
2
7
EQ15 Specifications
Input Impedance
Balanced 20 K ohms
Unbalanced 10 K ohms
Input Headroom
+ 23 dB
CMRR
>52 dB, 20 Hz to 20KHz
Output Impedance
Balanced 300 ohms
Unbalanced 150 ohms
Output Level (Max)
+ 23 dB
Filter
Two thirds octave, 15 x ISO standard
frequencies per channel
Filter Type
R/C active, MFB bandpass, Constant Q
Centre Frequency accuracy
±2% of nominal
Maximum Cut/Boost
±15 or 6 dB, switchable
Frequency Response
10 Hz to 20 KHz, ±.25 dB
Signal to Noise ratio
-93 dB Unweighted
-98 dB ‘A’ weighted
(All controls centred)
High Pass Filter
-3dB @ 30 Hz, switchable
Distortion
.0035% THD @ 0dB,1KHz
Dynamic Range
116 dB
Power Requirements
100/120 V AC 50 - 60 Hz
220/240 V AC 50 - 60 Hz
20 Watts (20 VA)
Weight
8 lbs/3.75 Kg
Dimensions
19"W x 3½"H x 9"D
482 x 89 x 230mm
Input Connector type
Jack and XLR
Output Connector type
Jack and XLR
This symbol indicates that a Slow Blow fuse is used in this
equipment. Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated
dangerous voltage within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important
operating instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORTANT -
PLEASE READ THIS FIRST
This is a dual voltage unit. It is essential that you check that the voltage
on the fuseholder cover below the AC connector on the rear of the chassis
is set correctly before connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not
insert power cable into unit until voltage has been correctly set. Do not
plug power cable into AC power until voltage has been correctly set
THIS IS SET FOR
100 V AC TO 120 V
AC OPERATION
THIS IS SET FOR
220 V AC TO 240 V
AC OPERATION
Complies with 89/336/EEC Electromagnetic
Compatibility Directive, amended by 92/31/
EEC and 93/68/EEC and meets the follow-
ing standards:EN 55013 : 1990, Sections
3.2 and 3.5 EN 55020 : 1988, Sections 4.3,
5.4, 6.2, 7.0, 8.0.
