Aruba AP-MC-SFP, Installation Manual

Page: 2 / 7

2
Aruba AP-MC-SFP Fiber Media Converter | Installation Guide
Installation
1. Align the metal bracket directly to the wall and install using the included wood screws and/or anchors. Make sure orientation is
correct and that the arrow is pointing up.
2. Insert the SFP module into the AP-MC-SFP media converter, as shown in Figure 1 , number 1.
3. Attach power option of choice, as shown in Figure 1 , number 2.
4. Attach the fiber optic cable, as shown in Figure 1 , number 1 into SFP module.
5. Connect the AP cable from the AP-MC-SFP media converter from port marked “AP” to the access point, as shown in Figure 1 ,
number 3.
Figure 1
Attach cables and SFP module
The instructions on this guide show the AP-MC-SFP media converter installed directly on the wall, with a cover
attached. The AP-MC-SFP media converter may also be installed on a wall box and use any of the following access
points: AP- 303H, AP-503H, and AP-505H in place of the cover.
Use the #6-32x1 Phillips drive screw or any appropriate thread for the mating wall box.
When running the wire through the wall, make sure to not over-bend as this can cause the cable to break.
AP
57V max 10.3A
POE IN
57V max 10.3A
48V 0.3A
48V 0.3A
1
3
2a
2b
2c
Fiber
AP
57V max 10.3A
1
2b
2c
3