AP 65 Mounting Kit Installation Notes
4
AP-65-MNT
0500204
Installation Notes
December 2005
Mounting To A Ceiling Tile Rail System
The AP 65 enclosure supports an integrated 15/16” ceiling tile rail guide slot,
designed to snap onto standard 15/16” tile rails (the use of this kit for this
purpose is not required).
To mount the AP 65 to a ceiling:
1.
Pull the Fast Ethernet (FE) cable through a prepared hole in a ceiling tile at the
location where you want to install the AP 65.
2.
Insert the FE cable into the FE port on the rear of the AP 65.
3.
Align the AP 65 with the appropriate ceiling tile rail, engaging the rail at
approximately a 30 degree angle (see
Figure 2
).
Figure 2
Engaging the ceiling tile rail
4.
Make sure the FE cable will retract into the ceiling area allowing the AP 65 to
fit flush against the ceiling.
5.
Pushing gently against the ceiling rail, twist the AP 65 clockwise until the AP
and the rail click into place (see
Figure 3
).
6.
Orient the antennas for optimal performance. Typically, the best results are
achieved when the antennas are oriented vertically.
2
3
Caution:
Make sure the AP 65 clicks into place on the tile rail. Failure to
securely engage the ceiling rails into the built-in ceiling tile rail
slots on the rear of the AP 65 could cause it to fall and
possibly injure people or equipment.
