Aruba 800-E, Installation Manual

Page: 25 / 52

Aruba 800-E 17
Installation Guide
Initializing the 800-E
Chapter 3
F
IGURE
3-1 Connecting the 800-E Access Multiplexer
N
OTE
: The 800-E can connect to a Master Switch or to a Mobility Controller
configured as a local to a Master Switch. In either configuration, the
800-E is considered a local switch. In the case of the 800-E being
connected to a local Mobility Controller, the Master Switch to this
Mobility Controller will provide Master Switch services to the 800-E such
as heartbeat.
Initial Switch Setup
The following procedure outlines the minimum, basic switch setup dialog
configuration required to enable access to the Web UI. If initial setup has already
been performed on your Access Multiplexer, you can use the CLI to change any of
the default or previously set parameters.
800-E Access Multiplexer
Master Switch
Local Switch
Master Switch
800-E Access Multiplexer