Aruba 800-E, Installation Manual

Page: 13 / 52

Aruba 800-E 5
Installation Guide
Installing the Chassis
2
This chapter covers the following installation topics:
„
Precautions to observe during installation
„
800-E Access Multiplexer components and rack mounting requirements
„
Selecting a proper environment for the 800-E Access Multiplexer
„
Mounting the 800-E Access Multiplexer in a rack
„
Connecting power to the 800-E Access Multiplexer
Pre-Installation Checklist
During installation, you will need the following:
„
Aruba 800-E Access Multiplexer chassis
„
Two mounting brackets (included)
„
Six 6-32 flat head screws (included)
„
Four 12-24 screws (included) or screws as appropriate for your rack
„
Aruba power cord rated to at least 10 A with IEC320 connector (included)
„
Phillips or cross-head screwdriver
„
19-inch equipment rack, or equivalent
„
1U rack space with 10 cm (4 inches) clearance to the left and right of the rack
„
Electrical power: 90~132/180~264 VAC, 50 to 60 Hz, 3.5/2.0 A
„
Cool, non-condensing air 0 to 40 ºC (32 to 104 ºF). May require air
conditioning
„
Another person to help position the switch
„
Console terminal (or computer running emulation software) with RJ-45 or
DB-9 serial port
„
RS-232 serial cable with RJ-45 male connectors (straight-through Ethernet
patch cable)
„
Aruba serial adapter (included) if connecting to the console with DB-9
C
AUTION
: Installation should be performed by a trained technician.