background image

4

Aruba 503H Hospitality Access Points  | Installation Guide

Console Port

The 5-pin Micro-B connector is located on the back of this device. Use the proprietary AP-CBL-SERU cable for 

direct management of this device when connected to a laptop or serial console (a standard USB cable cannot be 

used for this interface). For pin-out details, refer to 

Figure 4

.

Figure 4  

Micro-B Port Pin-out

Ethernet Ports

The Aruba AP-503H access points are equipped with one active uplink Ethernet port E0, shown in 

Figure 2

. The 

port is 10/100/1000 Base-T, auto-sensing MDI/MDX, which supports uplink connectivity when linked by an 

Ethernet cable. Refer to 

Figure 5

 

for a detailed port pin-out. The Aruba AP-503H access points support downlink 

network connectivity through E1-E2 Ethernet ports.

 

The ports are 10/100/1000Base-T auto-sensing MDI/MDX. 

Figure 5  

AP-503H (Ethernet Port)

Physical Security Options

A Kensington Lock Slot is available with the desktop mount accessory 

A security screw hole can be used with the mounting bracket

Reset Button

The reset button located on the side of the device (showed in 

Figure 2

) can be used to reset the access point to 

factory default settings or turn off/on the LED display. 

Use one of the following methods to reset the access point to factory default settings:

To reset during normal operation:

1.Hold the reset button for more than 10 seconds while the access point is running.
2.Release the reset button.

To reset during power up, hold the reset button while the access point is powering up.

The system status LED will flash again within 15 seconds indicating that the reset is completed. The access 

point will now continue to boot with the factory default settings.

To toggle the LED display between Off and Normal:
During the normal operation of the access point, shortly press and release the reset button using a small, 

narrow object, such as a paperclip. 

Bluetooth Low Energy / Zigbee Radio

Aruba AP-503H Access Points are equipped with an integrated BLE and Zigbee radio that provides the following 

capabilities:

location and asset-tracking applications

1: NC
2: RXD
3: TXD
4: GND
5: GND

Ethernet Port

RJ45 Female
Pin-Out

Signal Name

1
2
3
4
5
6
7
8

BI_DC+
BI_DC-

BI_DD+
BI_DD-

BI_DA+
BI_DA-
BI_DB+

BI_DB-

Function

Bi-directional pair +C
Bi-directional pair -C

Bi-directional pair +D
Bi-directional pair -D

Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B

Bi-directional pair -B 

Summary of Contents for 503H













Reviews: