6
Aruba 387 Series Outdoor Access Points
| Installation Guide
Installing the Access Point
Using Mount Kits
The 387 Series access point can be installed on a wall or attached to a pole by using mount kits:
To ensure successful point-to-point connection, the 387 Series access points should mount face to face as shown
Figure 4
Mounting AP-387 Face to Face
Grounding the Access Point
The grounding must be completed before powering up the access point. The grounding wire should be #8 AWG.
1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the included copper
lug, and press firmly with the crimping pliers.
2. Fasten the copper lug to the grounding hole on the access point with the included M4 x6 screw.
Service to all Aruba products should be performed by trained service personnel only.
Table 4
Applicable Mount Kits for 387 Series Access Point
Part Number
Description
JW054A
AP-270-MNT-H1 mount kit for hanging from inclined or horizontal structure.
JW055A
AP-270-MNT-H2 flush mount kit for wall and ceiling mounting.
The 387 Series access point does not ship with any mount kits. These mount kits are available as accessories
and must be ordered separately.
For installation instructions on AP-270-MNT-H1 and AP-270-MNT-H2 mount kits, please refer to the
AP-270-
MNT-H1 Installation Guide and AP-270-MNT-H2 Installation Guide
respectively.
