10
Aruba 318 Series Wireless Access Point
| Installation Guide
The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
Table 1
and
Table 2
). For instructions on initial setup and software configuration,
refer to the AP Software Quick Start Guide.
Electrical and Environmental Specifications
Electrical
Ethernet
One 10/100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces
Power over Ethernet (IEEE 802.3at compliant)
Environmental
Operating
Temperature: -40ºC to 55ºC (-40ºF to 131ºF)
Storage
Temperature: -40ºC to 70ºC (-40ºF to 158ºF)
Humidity: 5% to 93% non-condensing
For additional specifications on this product, please refer to the data sheet. The data sheet can be found at
www.arubanetworks.com
.
Regulatory Model Name
The following regulatory model names apply to the 318 Series:
AP-318: APIN0318
Safety and Regulatory Compliance
FCC
To view the FCC ID for controller-managed access points:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About
To view the FCC ID for Instant access points:
1. Log into the virtual controller WebUI
2.
Navigate to Maintenance > About
!
CAUTION
RF Radiation Exposure Statement:
This equipment complies with RF radiation exposure limits. This equip-
ment should be installed and operated with a minimum distance of 13.78 inches (35 cm) between the radiator
and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating in con-
junction with any other antenna or transmitter.
!
CAUTION
Déclaration de la concernant l’exposition aux rayonnements à fréquence radioélectrique (FR):
Cet appa-
reil est conforme aux limites d’exposition aux rayonnements FR établies par la FCC. Il doit être installé et utilisé
à une distance minimale de 35 cm (13,78 pouces) entre le radiateur et votre corps, qu’il opère sur la bande 2,4
GHz ou 5 GHz. Cet émetteur ne doit pas être installé ou utilisé à proximité immédiate d’une autre antenne ni
d’un autre transmetteur.
!
CAUTION
The device could automatically discontinue transmission in case of absence of information to transmit, or ope-
rational failure. Note that this is not intended to prohibit transmission of control or signaling information or
the use of repetitive codes where required by the technology.
