Art's Way LS1200R, Illustrated Parts List Set Up And Operating Instructions

Page: 8 / 38

viii
CAUTION: Remember, a careful
operator is the best insurance against
an accident.
CAUTION:
Read and Understand the
Operating Instructions and all the
safety decals before operating the
grader. Review all safety instructions with all
operators annually.
Before Operating
• Do not wear loose fitting clothing as it may
catch in moving parts
• Make sure to install and/or secure all guards
and shields before starting the tractor or
operating the grader.
• Check to be sure all hydraulic lines and
fittings are secure and that no lines are
crimped or worn. Tighten, adjust, and replace
as necessary. Do not attempt to make
temporary repairs to hydraulic lines.
• Install the safety chains when attaching the
grader to the tractor.
• Clear the area of bystanders, especially
children, when making adjustments, repairs,
or performing maintenance on the grader.
• Do not allow riders while transporting.
• Put all tractor and machine controls in neutral
before starting. Follow the starting
instructions according to your tractor Manual.
• Operate the grader only while seated on the
tractor seat.
• Make sure the unit is adequately supported
with safety blocks or stands when changing
tires or working on it.
During Operation
• Keep hands, feet, hair and clothing away from
moving parts.
• Keep all shields and guards in place and in
good repair.
• Keep all children and bystanders away from
the Grader when in operation.
• Do not allow riders while the grader is in
operation.
•
Do not
attempt to lubricate, repair or adjust
the grader while the tractor is running.
• Before servicing, adjusting, repairing or
unplugging the grader, stop the tractor engine,
place all controls in neutral, set the parking
brake, remove the ignition key, and wait for
all moving parts to stop.
• Keep all hydraulic lines, fittings, and couplers
tight and free of leaks. (See the Hydraulic
Safety section below.)
Maintenance Safety
• Follow all operating, maintenance and safety
instructions found in the Manual.
• Before servicing, adjusting, repairing or
lubricating the grader, stop the tractor engine,
place all controls in neutral, set the parking
brake, and remove the ignition key.
• Use only the tools, jacks and hoists that are of
sufficient capacity for the job.
• Use support blocks or safety stands when
changing tires or working under the machine.
• Follow the good shop practices of keeping the
service area clean and dry and use adequate
light for the job at hand.
Hydraulic Safety
• Before applying pressure from the hydraulic
system, make sure all lines, fittings, and
couplers are tight and in good condition.
• Relieve pressure from the hydraulic circuit
before servicing or disconnecting from the
tractor.
• Make sure all shields/guards are in place and
properly secured when maintenance work is
complete.
• Replace any worn, cut, abraded, flattened or
crimped hoses.
•
Do not
make any temporary repairs to the
hydraulic lines, fittings or hoses by using
tape, clamps, or cement. The hydraulic