INSTALLATION STEPS
Bracket Installation:
3. Attach bracket pieces 1,2,3, and 4 to towel warmer using diagram 1 below as a guide.
Typically the brackets are positioned between the 2nd and 3rd bars from the top and
bottom. To allow maximum hanging space for the towel, position brackets as near to
the edges as possible.
4. Determine location of #6 outer rear cylinder by measuring the brackets attached to towel
warmer. Attach #6 cylinder to wall with hole for #7 locking screw facing down on the bottom
brackets and facing up on the top brackets.
5. Push towel warmer onto the wall, inserting #4 into #6.
6. Insert lower locking screws ( #7 ) . Snap on caps #8.
Valve Installation: ( use Diagram on page 6 as a guide )
7. Thread # 1 male stub into female inlets on bottom of towel warmer using a threadlocking
substance.
8. Push # 2 compression fitting onto supply pipe and tighten onto valve body.
9. Tighten #1 male stub ( now attached to towel warmer ) onto valve.
10.Insert blanking plugs ( provided with brackets ) into female inlets located at the top of
towel warmer.
11.Check for leaks.
Diagram 1
#8 Cap
#1 Securing
Bolt
#2 Front Cylinder
Head
Horizontal Bars
#3 Rear Cylinder Head
#4 Inner Rear
Cylinder
#5 Wall Fixing
Screw
#7 Locking Screw
#6 Outer Rear Cylinder
