artograph Artist LED200, Operation Manual

Page: 6 / 60

Important Safety Information
•
Do not operate projector in wet or damp conditions or near water.
•
Do not handle projector with wet hands.
•
If projector becomes wet, unplug and do not use until inspected
by a qualified service person.
•
Keep projector free from dust, dirt, or debris.
•
Though the LED produces little heat, make sure the vents are not
blocked to allow air circulation.
•
Only plug into properly grounded outlet only. Do not cut off or remove grounding prong.
•
Make sure power cord is not where it can be stepped on or tripped over.
•
If using an extension cord, make certain it is a grounded cord with sufficient capacity.
•
Turn power off from projector or remote power button. Do not turn off by
pulling power plug.
•
Do not look directly into lens, light is very bright.
•
When cleaning, unplug the power. Wipe projector with a soft cloth. Do not use
cleanser, wax, spray water or wipe with a wet cloth.
•
Use an air spray or soft cloth that is slightly moist with a neutral detergent and water to
remove dust or stains on the projector lens.
•
Do not remove any covers. No user serviceable parts.
Artograph Digital Art Projector LED200 Operation Guide
6
Before You Start
Product Warranty
Artograph projectors are guaranteed against
all defects in material and workmanship for
one year from the date of sale to the original
purchaser. Any part of the equipment
which becomes defective under normal
installation and use will be repaired or
replaced without charge for factory labor
and materials’, providing the equipment is
returned, shipping prepaid, to our factory
within this period along with proof of
purchase. CONTACT OUR OFFICE FOR
RETURN AUTHORIZATION. This warranty
does not apply to equipment which has
been subjected to abuse, accident, or
alteration, nor to equipment which has been
improperly installed or wired in violation of
the printed instructions furnished. You may
register your Artograph product online at
www.artograph.com.