Programming (moody cvz1)
To enter programming mode, press and hold control for 3 seconds.
Step 1
moody’s indicator LED flashes
red
to acknowledge it has entered
colour programming mode, then shows the colour of the fixture.
Step 2 - programme the colour (hue)
a)
Wait 5 seconds; moody will start slowly cycling through the colour
palette. When you see the colour you want, briefly press the
control.
N.B. During the programming process, the fixture will change
colour to show the effect of your programming.
b)
Alternatively, rotate the control clockwise or counter-clockwise to
move forwards or backwards through the colour palette. When
you see the colour you want, briefly press the control.
Operation (moody cvz1)
Overview
y
moody cvz1
-
Controls a single RGB fixture with CV dimmer output at 12 - 24V
-Output is RGB common anode
-
Wheel controls fixture colour
From factory, all scene channels are programmed to cyan. At power on, moody will automatically
fade the master level to full over 5 seconds.
If lights are on, briefly press the control: moody fades the master level to zero over 5 seconds.
If lights are off, briefly press the control: moody fades the master level to full over 5 seconds.
Rotate control clockwise or counter-clockwise to change the colour of the fixture. The LED
indictor shows the master level (always 100%) and colour of the fixture.
To set a scene: please see programming instructions below.
