2 of 8
WARNINGS, TIPS, & REQUIRED TOOLS
Artillian products feature an assembly of parts designed for your vehicle which require
adjustment and alignment of components to accommodate vehicle variations and provide
proper installation. For accurate installation, proper operation, and years of satisfaction,
please read and understand the installation and owner’s manual fully prior to installing the
product.
From all of us at Artillian, we thank you for choosing our product
.
NOTICE
This product adds additional weight to the base vehicle. All product and accessory
weights are listed in the Installation & Owner
’
s Manual. Deduct the product (and
accessories) total weight from the vehicle
’
s rated capacity and never exceed the
vehicle
’
s rated capacity, including driver and passenger.
WARNING
!
!
This product is intended to increase the functionality of the UTV bed for use in SLOW
SPEED CONDITIONS. The weight and location of this product and its accessories
(when mounted on a UTV bed) will increase the vehicle
’
s center of gravity. This may
cause the vehicle to become less stable when driving. Additional caution should be
used when driving with this product installed, especially when multiple accessories
and/or tools are added.
TRAVEL SPEEDS MUST BE GREATLY REDUCED TO AVOID ROLLOVER. FAILURE TO
COMPLY COULD RESULT IN INJURY OR DEATH.
This product is not intended for use in trail riding, driving on particularly rough terrain,
on slopes, or at high speeds.
Do not attempt to dump the vehicle bed with accessories installed on either the Tool
Bar or the Tool Rack. Doing so may result in damage to the Tool Bar, the Tool Rack,
the Tool Bar Accessories, or to the vehicle bed or its dumping mechanism.
GENERAL INFORMATION BEFORE YOU START
To assist with installation, leave all fasteners loose for later adjustment unless otherwise specified.
Before installing parts with factory installed rubber, make sure the rubber is fully installed onto
parts for proper fit and finish. It is possible that the rubber has shifted during shipment.
Use caution to avoid damaging factory installed threaded inserts. Begin thread engagement by
hand to avoid or correct potential cross-threading.
TOOLS REQUIRED:
Set of Standard Drill Bits
Center Punch
Awl
C-Clamps
Set of Standard and Metric Sockets (3/8” Drive)
3/8” Drive Ratchet
Set of Standard and Metric Open-End Wrenches
Drill / Driver
