2 of 5
Fig. 1 (attaching the chainsaw mount)
ATTACH TO MOUNTING BAR:
Note: The Artillian ROPS Mounted Toolbar is designed to
hold multiple accessories at one time. If placed appropriately,
up to 3 separate accessories may be possible. For example,
the Chainsaw Mount, Fuel Can Holder, and Beverage Cooler
Holder were designed to fit on the toolbar simultaneously.
1. Figure 1 shows a chainsaw mount installed onto an
Artillian ROPS Mounted Tool Bar.
2. To install the chainsaw mount, rotate both cam
levers UP, then place onto the Tool Bar. See fig. 2.
Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one
of the clamp plates may not have been fully open. Simply remove the
chainsaw mount, rotate the cam levers up and tilt the chainsaw
mount away from you to ensure the clamp plates are fully open, then
reinstall on the Tool Bar.
3. To secure the chainsaw mount to the Tool Bar,
rotate both cam levers DOWN until they cam over.
See fig. 3.
NOTE: For additional security, the chainsaw mount can be locked to
the Tool Bar by inserting a padlock through the holes in the mounting
bracket where shown in fig. 3.
4. To remove the chainsaw mount from the Tool Bar,
rotate both cam levers UP, then lift the chainsaw
mount.
FEATURES AND OPERATION
1. For optimal functionality, the cam lever latches are
factory assembled with some friction between the
cam lever and the housing. This ensures the cam
lever doesn’t accidentally flip closed while the user
attempts to install it on the bar. If the cam levers
loosen up over time, simply tighten the nut and bolt
that secure the lever to the housing until the
desired resistance on the cam lever has been
achieved.
2. To install the chainsaw into the mount, pull the
quick release pin and rotate the chainsaw mount’s
cam lever down. See fig. 4.
3. Slide the chainsaw into the mount, per fig. 5.
FEATURES AND OPERATION
Fig. 2 (cam lever in the open position)
Fig. 3 (cam lever in the closed position)
rotate both cam levers up
to install the chainsaw mount
padlock holes
rotate both cam levers
down to secure the
chainsaw mount
Q.R. Pin
Fig. 4 (installing chainsaw, remove Q.R. pin)
Rotate
Lever Down
Bungee Cord
Mounting Holes
Cam Lever
Fig. 5 (installing chainsaw, slide chainsaw into place)
Slide do
w
n
