Trademarks
Contents subject to revision without prior notice. All
trademarks remain the property of their owners.
Copyright Statement
This publication may not be reproduced as a whole or
in part, in any way whatsoever unless prior consent
has been obtained from the owner.
FCC Warning
This Media Converter has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These
standards are designed to provide reasonable
protection against harmful interference when this
device is operated in a commercial environment. This
device generates, uses, and can radiate radio
frequency
energy
and
may
cause
harmful
interference to radio communications unless installed
in accordance with this User’s Guide. Operation of
this device in a residential area is likely to cause
harmful interference which will make the user
responsible for the appropriate remedial action at his
/ her own expense.
CE Mark Warning
This is a Class A product. In a domestic environment
this product may cause radio interference in which
case the user will need to consider adequate
preventative methods.
1. Checklist
The package should contain the following items:
- The Media Converter
- AC-DC Power Adapter
- User
’s Guide
Please notify your sales representative immediately if
any item is missing or damaged.
2. Overview
This Media Converter is designed to meet the
massive needs for Gigabit network deployment and
able to extend a copper based Gigabit network via
fiber cable. It is fully compliant with IEEE802.3,
802.3u, 802.3ab and 802.3z standards. It can be
installed into a 16-Slot Universal Media Converter
Rack. The installation and operation procedures are
simple and straightforward. Operation status can be
locally monitored through a set of Diagnostic LED
indicators located in the front panel.
Major Features:
- TP and Fiber Auto-Negotiation
- MDI/MDIX Auto-Crossover
- Flow Control and Back Pressure
- 9K bytes Jumbo Frame
- Store and Forward switching mechanism
- 1K MAC address
- Link Alarm
- 100/1000Mbps dual rate fiber uplink
3. Installation
- Attach fiber cable from the Media Converter to the
fiber network. The fiber connections must be
matched
– transmit socket to receive socket.
- Attach a UTP cable from the 10/100/1000BASE-T
network to the RJ-45 port on the Media Converter.
- Connect the power adapter to the Media Converter
and check that the Power LED lights up. The TX
Link/Act and F/O Link/Act LEDs will light up when
all the cable connections are satisfactory.
Fig 1. Front Panel of the Media Converter
Fig 2. Rear Panel of the Media Converter
