ArTi WH Compact 10L, Instructions For Use Manual, Page: 3 / 28

arti.ua 3
EN
BEFORE INSTALLING AND FIRST USING AN ELECTRIC WATER HEATER,
PLEASE READ THESE INSTRUCTIONS CAREFULLY.
INSTRUCTIONS FOR INSTALLATION AND USE.
•
Dear buyer, Thank you for the confidence you have shown by purchasing our product
from the series «WH Compact».
•
The benefits of choosing the model of the electric water heater «WH Compact»:
•
The design of the heater - ergonomic, creating it, we set ourselves the goal to occupy a
minimum of space in the room where it is installed.
•
The quality of the built-in water heater ensures long service.
•
35 years of experience in the production of water heaters - this is another reason to be
confident in the quality of the product we offer, in which you make through flawless operation.
•
The heater is made with the most modern equipment and advanced techniques that pro-
vide the lowest cost of energy for 24 hours.
This is achieved through the use of high quality insulation, which ensures minimal heat loss of
the heated water in the boiler.
•
A heater has a regulator that you can set the desired level of heat.
•
The power of the heater also provides a small electricity consumption during heating of
water, and the minimum scale formation. At the same time, the heating resistor of the boiler is
minimized.
•
The life of the boiler extended. The boiler is made of very dense material has a protective
coating to ensure a long service life with moderate use.
This water heater is manufactured in accordance with established standards and tested the rel-
evant services, as stated in the MSDS and Certificate of electromagnetic compatibility. Product
specifications are given on the label between the inlet and outlet pipes. Installation must be per-
formed by qualified personnel. All repairs and maintenance of the water heater, for example,
descaling or checking /replacing the anti-corrosion anode should be held by the representative
authorized service center.
FASTENERS
Type of electrical appliance WH Compact 5 to 10 liters, designed to be installed over or under
the sink, as well as the universal model. The model is intended to be installed above the sink, is
designated as SA, the model that is designed to include a sink, a designation SU, universal
model, which is designed to be installed, as under the sink or under the sink is designated U.
Installing the wall mount made of two screws in the attached figure. Screw holes with a diameter
of 5 mm.
The water heater should be located as close as possible to the drain. Placing it in a room with
bath or shower, consider the requirements listed in IEC 60364-7-701 (Association for Electrical,
Electronic and Information Technologies 0100 Part 701).
CONNECTING TO THE WATER
Connection to the water heater cold water inlet is marked in blue to exit hot - red (in the univer-
sal cylinder holes marked in red are two, one of which must necessarily leave the plug that
came with the
water heater). Connecting it in three ways, as shown in Figs.
Open gravity systems require the installation of one-way valves that prevent the discharge of
water from the tank if the water supply has slowed or stopped. In this mode, the mixer requires
instantaneous heating as tap flows when the volume of the heated water is increased. The flow
can not be stopped by tightening the faucet even more, on the contrary it can only damage the
valve.