ARTHUR HOLM DTalk, Assembling Manual

Page: 2 / 9

Information
Dynamic 3 monitor is available in a special version prepared to be
assembled with DynamicTalk device. This special version is supplied
with all accessories to be assembled.
DynamicTalk can be assembled at the right side, at left side or at both
sides. This guide shows how to assemble it at left side (the assembling
at the right side follows the same process).
INTRODUCTION
2
Manipulation of the product should be avoided, no stress should be applied to the product except from
the instructions given in this document. Cutting, drilling, soldering, adding of electrical and mechanical
components can cause danger and should be avoided by all mean. Not complying with these direction
will result in a lost of the Arthur Holm warranty. Albiral Display Solution S.L. shall not be held liable for
any loss or injury incurred as a result of modifications made to goods by anyone other than the supplier
or the supplier's authorised representative without the supplier's written permission. Such
modifications shall be deemed to terminate any further guarantee obligations. Compensation will not be
paid for wages, loss of profit, waste of time, packing and transport or any financial liability resulting
from defects in the goods. (Albiral Display Solutions shall not be liable for any loss or injury caused by
negligence.)
PATTERN HOLE
Pattern hole dimensions for milling are specified in the general dimensions for each reference.
ATTENTION