Arthrex Angel, Operator'S Manual

Page: 71 / 108

Programmability Option
Angel ® cPRP System Operator’s Manual
4-5
Renaming a Protocol
Follow these steps to rename an existing custom protocol. Note that the Standard
Protocol cannot be renamed.
1. Select the protocol you wish to rename, from the Protocol Pull-Down Button.
2. Touch the Rename Button. Touching the Rename Button will display the Keyboard
Screen on the Angel System’s Touch Screen Display (see Figure 4-2).
3. Use the “ Backspace ” Button to edit the previous name, or clear the previous name
by touching the “
Clear
” Button, located at the bottom of the Keyboard Screen.
Then type in the new name for the protocol.
You may exit the Keyboard Screen without causing any changes to take effect at any
time by touching the Close Button located at the upper right corner of the screen.
4. When finished, touch “
Enter ” to save the new name and return to the
“ Protocols ” tab.
5. Touch the Close Button to return to the previously displayed screen.
Changing the Wakeup Protocol
Follow these steps to set a protocol as the wakeup protocol (selected at power-up).
The wakeup protocol will be the selected protocol by default whenever the
Angel System is turned on.
1. Select the protocol you wish to set as the wakeup protocol, from the Protocol
Pull-Down Button.
2. Touch the “ Make this the default (wakeup) protocol ” Button.
3. Touch the Close Button to save the protocol and return to the previously
displayed screen.
Deleting a Protocol
Follow these steps to delete an existing custom protocol. Note that the Standard
Protocol cannot be deleted.
1. Select the protocol you wish to delete, from the Protocol Pull-Down Button.
2. Touch the Delete Button. The protocol will be deleted and will no longer be
available from the Protocol Pull-Down Button.
3. Touch the Close Button to return to the previously displayed screen.