5
Always disconnect from the mains, when the fixture isn’t in use or before cleaning it. Only handle
the power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and doesn’t
necessarily mean that the fixture is defective, it should decrease gradually.
Please don’t project the beam onto combustible substances.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent of a similar qualified person in order to avoid a hazard.
CAUTION!
Never touch the fixture during operation.
The housing may heat up.
CAUTION!
Never look directly into the light source, as sensitive persons may
suffer an epileptic shock.
Please be aware that damages caused by manual modifications to be the fixture aren’t
subject to warranty. Keep away from children and non-professionals.
CLEANING AND MAINTENANCE
1.
To reduce the risk of electrical shock or fire, don’t expose this unit to rain or moisture.
2.
Don’t spill water or other liquids into or onto your unit.
3.
During long periods of non-use, disconnect the unit’s main power.
4.
It should be installed in a well-ventilated place, at a distance of 50 centimeters or more with the
walls. At the same time, please check if the fan and ventilation holes are unobstructed.
The following points have to be considered during the inspection
1.
All screws for installing the lights or parts the light have to be tightly connected and must not
be corroded.
2.
There must not be any deformations on the housing. Fixations and installations spots(ceiling,
suspension, trussing).
3.
Mechanically moved parts must not show any traces of wearing and must not rotate with
unbalances.
4.
The electric power supply cables not show any damage, material fatigue or sediments. Further
instructions depending on the installation spot and usage have to be adhered by a skilled installer
and any safety problems have to be removed.
CAUTION!
Disconnect from mains before starting maintenance operation.
In order to make the lights in good condition and extend the lifetime, we suggest a regular
cleaning to the lights.
1.
Clean the inside and outside lens each week to avoid the weakness of the lights due to
accumulation of dust.
2.
Clean the fan each week.
3.
A detailed electric check by approved electrical engineer each three month, make sure that the
circuit contacts are in good condition, prevent the poor contact of circuit from overheating.
