ARTEX PRODUCTS / ACR ELECTRONICS, INC.
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
ELT 1000 (P/N: A3-06-2749-1)
Y1-03-0259 Rev. U
Company Confidential
Page 33 of 62
REMOVAL
1.
ELT
A.
ELT Removal
1)
See Figure 9 ELT Removal Sequence.
Figure 9 ELT Removal Sequence
2)
Disconnect the antenna coax cable.
NOTE:
Check the coax cable center conductor pin which is prone to retracting into the connector
housing.
3)
Remove remote switch harness D-sub plug.
4)
Open the metal strap.
NOTE 1:
When opening the metal strap, use caution to avoid pinching your fingers in the latch. A flat
screwdriver can be placed under the latch to “spring” it open if needed.
NOTE 2:
Never open the strap by prying it open from the top. Once the latch is disengaged, loosen the
straps from the sides only, as shown by the arrows in Figure 10.
