Y1-03-0272-1 Rev. C
A3-06-2824-1 Handheld Programmer Operations Manual
Company Confidential
Page 27
11.
Verify ELT u
sing “Sarcalc”
, as described in Subsection 5.2.
4.6.12 National Location / ELT Serial (Long)
1.
Select ELT 9600 Baud rate or ELT 345/1000.
2.
Select Protocol.
3.
Select Country Code.
4.
Go to Graffiti screen and tap on letter/numbers.
5.
Enter the serial number, which matches the serial number seen on the product
label, or a number that was designated for use by the competent national
authority.
6.
Tap
“
Done
”
when finished.
7.
Tap “ENTER” button on Program screen
. The 32-digit hex code is shown at the
bottom of the screen, with the abbreviated 15-digit hex code below it.
8.
Tap the “Program” button to program the ELT
.
9.
Ensure that screen shows “Programming Successful”.
10.
Verify ELT u
sing “Sarcalc”
, as described in Subsection 5.2.
4.7
Programming a Different Country Code for use with a Specific 24-Bit
Address
1.
Follow the instructions for the 24-bit address method being used (short or long).
Refer to Subsection 0, 0, or 0, as appropriate.
2.
After using
“Enter” button function,
go to the top of the screen and tap
on “Artex
ELT Programmer bar”
.
3.
Tap
on “Options”
.
4.
Select “Defaults”
.
5.
Tap
in “Country” entry space and go to numbers selection on
Graffiti screen.
6.
Enter required country code.
7.
Tap
“
Done
”
when finished.
8.
Tap
“
R
eturn”
on the Override default screen.
9.
Tap
“Program”
on the Programmer screen.
10.
After programming successfully, launch Sarcalc and verify programmed information,
as described in Subsection 5.2.
4.8
Programming Conclusion
After programming an ELT with any of the protocols listed in Subsection 4.6, the
“Programming Successful”
screen will be displayed.
