English - P 15
Operating anomalies
When starting up
The compressor will not operate :
- Ensure that there is power to the electrical supply plug by connecting another
electrical appliance to it.
- ensure that the wall socket is supplied with power by plugging in another
electrical appliance.
- ensure that the temperature set values comply with the values given in the
paragraph “Temperature setting”.
- the temperatures obtained are lower than or equal to the set value of the cold
thermostat (desired temperature). In this case, the compressor will not start
because the desired temperature has been obtained.
Adjust the 2 thermostats so that they are in the stop position at the coldest
possible setting to check if the compressor is starting up.
Please note: the compressor will not start if the temperature inside the
appliance is below 7°C.
The compressor will not turn off:
1- Place your hand on the condenser (metal grill located along the exterior wall
behind your cabinet). If the condenser is cold, get in touch with your retailer.
2- If the condenser is hot, turn the cold adjuster to its highest level, if the
compressor does not stop, get in touch with your retailer.
In operation
The control thermometer indicates a lower value than the one required:
Check the settings in relation to the table on page 10. If these settings are
correct, then adjust (see page 11).
The control thermometer indicates a higher value than the one required:
Check the settings in relation to the table on page 10. If these settings are
correct, then adjust (see page 11).
Any intervention on the cold circuit should be performed by a refrigeration
technician, who should carry out an inspection of the circuit sealing system.
In the same way, any intervention on the electrical circuit should be performed
by an electrician.
The power cable is fitted with an earthed plug standard to the country of consi-
gnment. It is essential that, for your safety, the electrical supply to the cabinet be
earthed. Please have the suitability of the socket checked by a qualified electri-
cian, who will make sure that it is properly earthed and, if necessary, repair it.
Only a qualified electrician should make any repairs or inspections to your
electrical supply.
ANy INTERVENTION PERfORMED By A TECHNICAL SERVICE
NOT APPROVED By ARTEVINO OR ITS RETAILER WILL LEAD TO
THE gUARANTEE BEINg CONSIDERED AS NULL AND VOID.
Belangrijk
