ATCA-7365-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Finding more information
For more information on the product, see
the
ATCA-7365 Installation and Use
and other
related documentation.
Visit our Web site
http://www.artesyn.com/
computing
. Use SUPPORT>TECHNICAL
DOCUMENTATION link to look for technical
documentation.
Technical Assistance
To request technical assistance, visit our
Web site
http://www.artesyn.com/com-
puting
.
1. If necessary, remove the blade from the sys-
tem.
2. Plug the memory module on the blade so
that the module's standoffs fit in the blade's
mounting holes.
3. Fasten the memory module to the blade
using the two screws that previously had
fixed the memory module to the blade.
4. Reinstall the blade in the system.The addi-
tional resource will be detected automatically
during the boot-up sequence.
5
Install the PMEM/SATA
memory module
55
Install the USB 2.0 flash
module
Note:
• Some blade variants come with the
flash module already installed.
6
1. If necessary, remove the blade from the
system.
2. Insert the new flash module in the
socket.
3. Tighten the screw on the left side
of the flash module.
Install the PMEM/SATA
memory module
The following procedure assumes that the system
is powered. If it is unpowered, you can disregard
the blue LED and skip its respective step.
5
Install the PMEM/SATA
memory module
1. Ensure that the top and bottom ejector handles
are in the outward position by squeezing the
lever and the latch together.
2. Insert the blade into the shelf by placing the top
and bottom edges of the blade in the card
guides of the shelf. Ensure that the guiding
module of the shelf and blade are aligned prop-
erly.
3. Apply equal and steady pressure to the blade to
carefully slide the blade into the shelf until you
feel resistance. Continue to gently push the
blade until the blade connectors engage.
4. Squeeze the lever and the latch together and
hook the lower and the upper handle into the
shelf rail recesses.
5. Fully insert the blade and lock it to the shelf by
squeezing the lever and the latch together and
turning the handles towards the face plate.
If your shelf is powered, as soon as the blade is
connected to the backplane power pins, the
blue LED is illuminated.
When the blade is completely installed, the blue
LED starts to blink. This indicates that the blade
announces its presence to the shelf manage-
ment controller.
Note: If an RTM is connected to the front blade,
make sure that the handles of both the RTM
and the front blade are closed in order to
power up the blade’s payload.
5
Install the PMEM/SATA
memory module
7
Install the blade (cont.)
7
6. Wait until the blue LED is switched off, then
tighten the face plate screws which secure
the blade to the shelf.
The switched off blue LED indicates that the
blade’s payload has been powered up and
that the blade is active.
7. If necessary, connect cables to the face plate.
