ARTM-9405 16x10GbE-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Finding more information
Visit our Web site
http://www.artesyn.com/computing
Use the Product Search link to look for techni-
cal documentation.
Technical assistance
To request technical assistance, visit our
Web site
http://www.artesyn.com
The following procedure assumes that the
system is powered. If it is unpowered, you
can disregard the blue LED and skip its
respective step.
1. Locate the slot where the RTM is to be
installed in the shelf’s rear, which must be the
same as that of the front blade.
2. Open the lower handle of the front blade to
power down its payload. The blue LED on the
front blade starts to flash.
3. Wait until the blue LED on the front blade is
lit.
4. Make sure that the top and bottom handles
of the RTM are in an outward position by
squeezing the lever and latch together.
5. Insert the RTM into the shelf by placing the
top and bottom edges in the card guides of
the slot.
6. Slide the RTM into the slot.
7. Apply equal and steady pressure to the RTM
to carefully slide it into the shelf until you feel-
resistance.
8. Continue to gently push the RTM until the
RTM connectors engage.
9. Squeeze the lever and latch together, and
then hook the lower and upper handle into
the shelf rail recesses.
Install the ARTM-9405
16x10GbE (cont.)
10. Fully insert the RTM and lock it to the shelf
by pressing the two components of the
lower and upper handles together, and then
turning the handles toward the face plate.
11. Close the lower handle of the front blade so
that the payloads of the RTM and front
blade are powered up.
12. Tighten the face plate screws on the RTM.
13. Wait until the blue LEDs on the front blade
and the RTM are not lit.
14. Plug the interface cable into the face plate
connectors, if applicable.
4
4
Install the ARTM-9405
16x10GbE
