Artecta A0690001, User Manual

Page: 18 / 44

17
Aqua Spot 200
Product code: A0690001
Free-standing Bracket Installation
01) Put the free-standing bracket on the Aqua Spot 200.
02) Install all elements as shown in Fig. 08.
03) Tighten the screws.
Fig. 08
Connecting to Power Supply
DANGER
Electric shock caused by short-circuit
The device accepts AC mains power at 100–240 V and 50/60 Hz. Do not supply power at any other
voltage or frequency to the device.
This device falls under IEC protection class I. Make sure that the device is always electrically connected
to the ground (earth).
Before connecting the device to the socket-outlet:
●
Make sure that the power supply matches the input voltage specified on the information label on
the device.
● Make sure that the socket-outlet has ground (earth) connection.
Connect the device to the socket-outlet with the power plug. Do not connect the device to a dimmer
circuit, as this may damage the device.
This device is IP65 rated.
● Do not expose the device to conditions that exceed the rated IP class conditions.
● Keep the connectors sealed with the rubber caps when the connectors are not in use.
● Do not connect the cables from above the connectors, if the device is installed outdoors. Make a
‘drip loop’ in the cable so that rain water cannot enter the device.
● Make sure that the cable run is not too heavy. A heavy cable run can cause damage to the
connectors. If the connectors are damaged, their ingress protection (IP) can deteriorate.