01.20.16 | Rv1 | CC2125
DISCOVER | INSTALLATION INSTRUCTIONS
Caster Option (From page 1, Follow Steps 1-2 first)
1.
For caster option, locate included caster package
2.
For pedestal casters, locate notches in each corner of pedestal bottom.
Pedestal Casters - Front
Pedestal Casters – Rear
3.
Remove glides and glide towers. KEEP Screw (use to install caster plate) and discard metal tower.
4.
PEDESTAL CASTERS - FRONT
a.
Insert corner of caster base into notch along front wall of pedestal. Align slotted hole in caster
base with hole in pedestal bottom. Note: if holes do not align, caster is not oriented correctly.
Remove and reorient caster.
b.
Use the Phillips screwdriver to install screw through slotted hole in caster base and into hole in
pedestal bottom. Fully tighten screw. Repeat steps 4a & 4b for remaining casters.
5.
PEDESTAL CASTERS - REAR
a.
On rear of pedestal, insert corner of swivel caster base into notch along rear wall of pedestal.
Align hole in caster base with hole in pedestal bottom. Note: if holes do not align, caster is not
oriented correctly. Remove and reorient caster.
b.
Use Phillips screwdriver to install screw through slotted hole in caster base and into hole in
pedestal bottom. Fully tighten screw. Repeat 5a & 5b for remaining swivel casters.
6.
SINGLE PEDESTAL DESK LEG CASTERS – POST LEGS (H Leg Option)
a.
Remove threaded glide, insert and tighten casters on both height adjustable legs.
b.
Adjust leg height 2” lower to accommodate casters. This is accomplished by removing screw
with 3/16 allen wrench and reinserting screw two holes lower (closer to glide) and tightening.
6.
SINGLE PEDESTAL DESK LEG CASTERS – T-LEGS (TH)
a.
Push 75mm casters into openings on bottom of T-Leg foot.
