8 Learning More, Service, and Support
8.1 Online Resources
7.2 Resetting back to factory defaults
While in this mode, the access point will not pass data through the ENET 0 port and will
broadcast an SSID that contains a portion of the access point’s MAC Address. You can use
any Wi-Fi enabled device to connect to this SSID and configure the network settings for this
access point using a web browser
To connect to the access point using the Local Network Configuration interface:
1. Connect your Wi-Fi enabled device to the SSID in the form of “AP-XX:XX:XX” (where
X is a placeholder). You are successfully connected when the LED on the Access
Point becomes solid purple
2. Use your web browser to navigate to http://192.168.100.1
3. Follow the on-screen instructions
See the Support section (http://art2wave.com/support) for information about Local Network
Configuration.
Note: Local Configuration mode will only activate if the access point is in Factory Default
condition and has never connected to the Art2Wave management services in the cloud.
If the access point is disconnected from a power source, press and hold the reset button, and
connect power to the unit. The LED will turn solid white to indicate the unit is restoring itself to
Factory Defaults.
OR
If the access point is connected to a power source, press and hold the reset button until the
LED turns solid white and then release. This will restore the unit to the factory default settings.
Our support website (http://art2wave.com/support) contains links to online resources available
to help you get the most out of your access point.
