SSA
AFFE
ETTY
Y PPR
RE
EC
CA
AU
UTTIIO
ON
NSS
Warning: To avoid the risk of shock or fire, do not expose this unit
to moisture. Do not remove metal panels from chassis parts.
Removing the chassis from its cabinet parts exposes dangerous
high voltages. There are no user-serviceable parts inside. Refer all
servicing to qualified personnel. Note: If your power cord
becomes damaged and must be replaced, always replace it with
the proper type (3 prong.)
PPO
OW
WE
ER
RIIN
NG
G U
UPP
When the rear panel power switch is turned on, the power indica-
tor LED will illuminate. It is important to remember to turn the Tube
PAC on before any monitoring levels or power amps are turned
on. The Tube PAC has the ability to add over 60dB of gain to its
input signal. This can cause the Tube PAC to produce a “thump”
on power up and power down.
N
No
ottee:: Like all tube-based equipment, the Tube PAC needs to warm
up before being used. Allow one to two minutes for the tubes to
reach proper operating temperature before using.
If the Tube PAC fails to power up when the power switch is turned
on, check to see that its power cord is plugged into an active out-
let. If the unit still fails to operate properly, turn it off and unplug
it. Then consult your dealer or A R T’s Customer Service depart-
ment.
FFR
RO
ON
NTT PPA
AN
NE
ELL C
CO
ON
NTTR
RO
OLLSS &
& IIN
ND
DIIC
CA
ATTO
OR
RSS
G
Ga
aiin
n C
Co
on
nttrro
oll
The Gain control sets the amount of input gain of the Tube PAC.
Turn the control clockwise to increase gain and counterclockwise
6
