Art-Tech P-51D Gunfighter, Instruction Manual

Page: 5 / 18

5
Charge Mode and Warning
Li-Po battery(balance changer)
ATI-0910 Li-poly battery balance charger using instruction
Specifications
:
Input voltage: DC 10V~15V
Output voltage: DC 7.4V&11.1V
Charge current: 0.3A~1.2A
Indicator state:
LED light near to the battery plug turns red:
the charger have connected the power supply.
LED light near to the DC port turns red: under charging
LED light near to the DC port turns green: full charged
LED light near to the DC port extinuishs: no charging
Separated battery detection: The voltage of any battery reaches
4.2V, the charge of it will cease automatically.
Using method:
1. Connect the mans adaptor to the charger as per the above image.
2. Connect the adaptor to the 240v supply, the LED should turn red indicating that it is ready to
charge.
3. Connect the battery to the charger per its interface mark. The LED becomes red, which means
the battery is on the way.
4. The LED turns green when fully charged ( if the light is not green after four hours remove from
charge and use any way ) and then the battery is ready to be used.
Notice
1. Do not insert any conductive into the cooling hole when power is on, or damage will be caused
to the charger.
2. While charging is in process, please do not place it near flammable materials.
3. Expect Li poly battery, this charger is not allowed for other kinds of battery.
4. While charging, please keep it out of the reach of Children.
5. When this charger is in use, please do not go away and leave it unwatched, if any abnormality
occurs (such as the power indicator is off, the temperature of the battery rise rapidly, etc.) stop
charging immediately.
6. Please do not use power with output voltage higher than 18V.
7. Please do not disassemble the charger or its accessories.
8. When the battery is not cool down, please do not urge to charge it.
www.motionrc.com