2 T–8000 8x8 Audio Matrix and Paging Controller
Page
9
2.4 System Address
Up to four T–8000 may be connected together to form a bigger system. The extension affects only the number
of addressable zones. Only the signal inputs of the main device (Master) are active. All other inputs of the
extension (slave) devices with the exception of the zone inputs are deactivated.
The T–8000 units are interconnected via the
EXTENSION LINK
sockets. In each case two devices are being
connected via a 37 pin ribbon cable with male and female Sub-D connectors.
A DIP-Switch on the back of the unit determines the status of the T–8000 device either as master or slave
(extension) device. For a each device the corresponding switch has to be set to
ON
.
Caution
For a standalone T–8000 the master switch has to be set to
ON
A maximum of 2 paging microphones T–8000A (refer to
) can be connected to an
extended system.
A T–8000B/BW (refer to
) per zone may be connected to the extension units.
2.5 Selection Mode
After selecting a zone with the
SOURCE
,
ZONE SELECT
oder
BGM ALL
key, the
ENTER
key needs to be pressed
and held down for 10 seconds. The display will blink during this time. Other than that the previous setting
will be kept.
The process my be stopped any time by the
ESC
key.
2.6 Source Select
The
SOURCE UP
and
SOURCE DOWN
keys select the signal sources of a zone:
•
L1-L8: Line 1–4 and Line/Mic 5–8 inputs
•
L: Remote input (PHOENIX) from the wall mounted control module (RJ45)
•
OF: No source selected
Caution
The Remote input (PHOENIX) can only be output in the selected zone.
The
BGM ALL
key assigns Line 1 to all available zones.
c
2017 MediasPro Medientechnik GmbH