Mounting Instructions
ASSEMBLY PROCEDURE WHEN MOUNTING TO VERTICAL SIDED BUILDINGS WITH 60" (152,4 cm) WALL HEIGHT
1
Locate shelf unit on desired wall. Drill two
1/4" (6 mm) dia. holes through upper wall
angle and wall panel 32 3/8" (82,2 cm) apart,
3/8" (10 mm) below top flange of angle.
2
Using a square or level measure down
29 1/2" (74,9 cm) from each hole. Check
bottom holes to make sure they are 32 3/8"
(82,2 cm) apart. Drill two 1/4" (6 mm) dia.
holes at these locations.
3
Temporarily remove the two bolts and nuts
from the back of the bottom shelf. Position
shelf aligning holes in rear posts with holes
drilled in panel and fasten with four #8-32x
1 1/2" (38 mm) bolts and nuts and either 3/4"
(19 mm) or 1" (25 mm) shims. Hardware for
mounting shelf unit is not supplied. Consult
your local hardware store for these parts.
1
Follow directions for Steps 1 and 2 above.
2
Temporarily remove the two bolts and nuts
from the back of the bottom shelf. Position
shelf aligning holes in rear posts with holes
drilled in panel and fasten with four
#8-32x1/4" (6 mm) bolts provided, as shown.
* Shelf may be attached to horizontal sided buildings
if located between wall studs using this procedure.
ASSEMBLY PROCEDURE WHEN MOUNTING TO VERTICAL SIDED BUILDINGS WITH
62" (157,5 cm), 67" (170,2 cm) or 71 1/4" (181,0 cm) WALL HEIGHT*
ASSEMBLY PROCEDURE WHEN MOUNTING TO HORIZONTAL SIDED BUILDINGS OVER VERTICAL WALL STUDS
1
Follow directions for Steps 1, 2 and 3 above.
Drill 1/4" (6 mm) dia.
holes through siding
panel and angle
#8-32
Hex Nut
Drill 1/4" (6 mm) dia.
holes through wall panel
#8-32x1 1/2"
(38 mm) Bolt
3/8" (10 mm)
29 1/2" (74,9 cm)
Drill 1/4" (6 mm) dia. holes
through siding panel
3/4" (19 mm) or
1" (25 mm) Shim
#8-32x1 1/2"
(38 mm) Bolt
29 1/2" (74,9 cm)
3/8" (10 mm)
32 3/8"
82,2 cm
Temporarily
remove two bottom
bolts and nuts
Drill 1/4" (6 mm) dia.
holes through
wall panel
29 1/2" (74,9 cm)
Drill 1/4" (6 mm) dia. holes
through wall panel and angle
Drill 1/4" (6 mm) dia.
holes through wall panel and angle
3/8" (10 mm)
717451111
32 3/8"
82,2 cm
32 3/8"
82,2 cm
#8-32
Hex Nut
3/4" (19 mm) or
1" (25 mm) Shim