28
Step 15
D28
●
Parts Needed For
●
Ridge Caps & Panels
●
●
●
●
●
8840 Ridge Cap (3)
●
●
●
●
●
5209 Roof Panel (2)
●
●
●
●
●
8486 Ridge Cap (3)
1
Install the 3
ridge caps
on the
completed roof section using bolts
and nuts. Fasten roof panel overlaps
not used for ridge cap. Cover the
head of bolt with the 3" (8 cm) piece of
weather stripping tape. Do not fasten
the ends of the ridge caps at this time.
2
Install the second
ridge caps
over-
lapping the first ridge caps while in-
stalling the remaining narrow
roof
panels
. Cover the notched areas of
the roof panels with strips of weather
stripping tape and continue weather
stripping the ridge.
3
Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of the panel.
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown.
Apply pressure with one hand at the
peak of the gable and tighten bolt #1.
Keeping pressure on the gable work
down the slope tightening each bolt.
Excess material will overlap smaller
gable at seam. Once material bulge
is worked out tighten 4 vertical bolts
that connect the large and small
gables.
STEP
2
5209
8486
3
STEP
8486
8486
5209
Cut Weather
Stripping and
Fold Under
STEP
1
8840
8840
8840
FRONT
FRONT
