© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
DESIGNED FAST. DESIGNED TOUGH.
12
Chassis Maintenance
AFTER RUNNING:
En s u r e t h a t d r i v e t r a i n , s u s p e n s i o n a n d
steering are clean, free and lubricated
Check that all the screws are tight
Check tyre/wheel condition
Tools Required
Tools Required
N.B. Raider chassis shown as an example - information applies to all variants.
N.B. Fury shown as an example - information applies to all variants.
DO NOT RUN THE CAR IF ANY
PARTS ARE DAMAGED
Please contact your local distributor
to order replacement parts.
Online videos when
you see this icon >>
Automotive
Brake
Cleaner or
Nitro Car
Cleaner
Cloth
Brush
Wheel and Tyre Maintenance
2
3
4
1
Visually inspect the tyre sidewalls and tread
for damage or heavy wear. Replace wheel
and tyre if either is found to be worn. Check
that tyre bead is securely glued to the rim.
If the tyre needs re-glueing, gently pull tyre away
from the wheel rim, apply a small amount of tyre
glue, re-seat the tyre and hold until glue has set.
Refit the wheel with a 7mm nut driver or cross wrench 'finger-tight',
then tighten a further 1/4 turn. Do NOT over tighten the wheel nut or
damage to the wheel bearings may occur.
Ensure model is switched off and drive
battery is removed; then remove wheel with
7mm nut driver or crosswrench.
7mm Nut Driver
or
Cross Wrench
Tyre Glue
ARRMA-RC.COM/
SUPPORT/
ARRMA-RC.COM/
SUPPORT/
Summary of Contents for ADX-10
Page 1: ...380037 ...
Page 40: ......
