16
Preparing Your Site
Arrive HuddlePoint™
- 4010 - CMMH- User Guide
2. Preparing Your Site
1.
The Arrive HuddlePoint™ 4010-CMMH is a BYOC Cable,Power and Media Management Hub
meant to be installed in huddle and meeting spaces to provide a walk-up-connect-and-use
experience from a single, integrated device. A flat surface such as a table is needed to
install (flush-mount) HuddlePoint.
2. Determine where the display will be located and mount the Arrive AHP-4010-CMMH on a
flat surface such as a table, appropriately near the display, for a 6ft HDMI cable to connect
to a display.
3. Ensure the AHP-4010-CMMH is situated near an available AC electrical outlet.
Note:
If connecting HuddlePoint with a wireless media gateway,
the hub’s maximum distance for wireless coverage is limited within
an unobstructed 12-15 feet circumference. If the wireless signal is
obstructed by walls, or other interference, the signal quality and
maximum distance will likely be reduced.
3. Hardware Installation
Before installing the HuddlePoint , it is recommended to read the enclosed
Quick Installation
Guide
carefully. A professional hardware installer may be needed to physically mount the hub
to a table.
1. Prepare the surface where the hub will be installed on (e.g. table surface) using the
instructions outlined in the enclosed Quick Installation Guide.
2.
Connect the mouinting bracket and cable management comb to the device.
3.
Connect the video-source cables (VGA/Display port/HDMI) on the bottom rear panel of the
hub, passing through the cable comb and out to the top panel. Lock the cable comb.
4. Install the hub on the table, and connect the HDMI video cable from the HDMI out port on
the recessed back panel (B) of the hub to the HDMI in port on the HDMI enabled display.
5. Connect the power adapter from an available AC outlet to the power adapter port on the
hub.
6.
The device powers on automatically. Screen should be able to show image from connected
wired device.
