3
motor. If you do not notice them and run the gimbal, they may burn the motors.
2.6
When you use the gimbal, make sure you tighten the camera. If the camera is not
tightening enough, it may cause the high frequency vibration.
2.7
The connector on Zhao Yun is JST, 1 (black) is “negative electrode”, and the other
1 (red) is “positive electrode”. Pay attention to the electrode, if you connect the
wrong side, it may burn the main board.
2.8
Before you power on it, please check the wires of the gimbal. Make sure the wires
are not twined, the gimbal can move without any block.
2.9
Before you power on the gimbal, please install the camera on it.
2.10 If you want to use all the functions of ARRIS ZHAOYUN 3-Axis, you need to
make sure there are 4 extra Channel on the Radio.
2.11 In order to ensure the normal operation of ARRIS ZHAOYUN 3-Axis, YAW
should connect with radio and do some setting. Then the gimbal can adjust the
direction effectively.
2.12 Before the initialization of the ZHAOYUN 3-Axis, please make sure that the
front of the gimbal stays the same direction as the front of the multicopter. If there is
some deviation after you power the gimbal, we suggest you use the radio to adjust the
direction of the gimbal. If the gimbal does not connect with the radio, the default
mode is Follow Mode. If the gimbal connects with the radio set, the gimbal mode is
decided by the mode switch.
2.13 In any mode, you can manual control the direction of the Yaw Axis of the
gimbal.
3
. How to Install the Camera
3.1 Install the camera in the frame of the gimbal, put the back of the camera close to
the back of the gimbal.
