Arris NVG595, Administrator'S Handbook

Page: 126 / 226

Administrator’s Handbook
126
Filterset commands
Filtersets provide packet filtering and QoS configuration. Packets are identified by characteristics that allow
QoS and forwarding decisions to be made. These characteristics can be at the MAC layer, IP layer, TCP | UDP |
ICMP layer(s), or (in applicable circumstances) 802.1q/p (VLAN-tagging) layer.
Your Gateway is capable of adding and stripping 802.1Q tags to and from frames before transmission on its
LAN interfaces. See also
“Link commands” on page 144 for more information.
A maximum of 8 filtersets are supported. Each filterset can have up to 8 rules configured. A maximum 8 egress
queues are supported. Each queue can have up to 8 entries.
A filterset rule identifies packet attributes to match with its
match
parameters. It acts on these packets using
its
default action
parameters.
set filterset name filterset_name rule number order number
Determines order of execution of filterset rules (1 before 2, etc). If
order
is unspecified, the value of
order
is
set to 1 more than the last order in the filterset. If
order
is set to an already existing order value, order values
of other rules are incremented automatically.
set filterset name filterset_name rule number enable [ on | off ]
Dynamically enables or disables the specified filterset rule.
set filterset name filterset_name rule number match-eth-proto number
Matches ethernet protocol field to the supplied value.
set filterset name filterset_name rule number match-eth-length number
Matches ethernet length field to the supplied value.
set filterset name filterset_name rule number match-eth-p-bits number
Matches VLAN priority bits.
set filterset name filterset_name rule number match-eth-vid number
Matches VLAN id number.
set filterset name filterset_name rule number match-eth-src-mac-addr mac_address
Matches supplied source MAC address field.
set filterset name filterset_name rule number match-eth-dst-mac-addr mac_address
Matches supplied destination MAC address field.
set filterset name filterset_name rule number match-src-ip-addr ip_address_range
Matches supplied value with packet's source ip address field.
set filterset name filterset_name rule number match-dst-ip-addr ip_address_range
Matches supplied value with packet's destination ip address field.