Arris CHP Max5000, Equipment Manual

Page: 17 / 267

1508685 Rev D Introduction 1-5
Statements of Compliance
FCC Compliance
This equipment has been tested and found to comply within the limits of FCC Part 76,
Subpart K. These limits are designed to provide reasonable protection against harmful radio
communication interference when the equipment is operated in a commercial environment.
This equipment can radiate radio frequency energy, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Changes or modifications to this device not expressly approved by ARRIS may cause the
operation of this device to violate Part 76 of CFR 47, voiding the user’s authority to operate
the equipment in the domestic US.
FDA Compliance
This device complies with 21 CFR 1040.10 safety requirements for laser radiation products.
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. In accordance with 21 CFR 1002, this
product has been registered with the FDA CFRH.
CE Compliance
This device conforms to the requirements specified in Table 1.1 on page 1-5 of Council
directive 89/336/EEC.
Table 1.1 CE Compliance Requirements
Requirement Description
EN50083-2 Cable networks for television signals, sound signals and interactive services -
electromagnetic compatibility for equipment
EN55022 Information technology equipment - radio disturbance characteristics - limits and
methods of measurement
EN61000-3-2 Electromagnetic compatibility (EMC) - limits - limitation for harmonic current
emissions (equipment input current up to and including 16A per phase)
EN61000-3-3 Electromagnetic compatibility (EMC) - limits - limitation of voltage changes, voltage
fluctuations and flicker in public low-voltage supply systems, for equipment with rated
current <= 16 A per phase and not subject to conditional connection
EN61000-4-2 Electromagnetic compatibility (EMC) - testing and measurement techniques -
electrostatic discharge immunity test - basic EMC
EN61000-4-3 Electromagnetic compatibility (EMC) - part 4-3: testing and measurement techniques -
radiated, radio-frequency, electromagnetic field immunity test
EN61000-4-5 Electromagnetic compatibility (EMC) - testing and measurement techniques - surge
immunity test
EN61000-4-6 Electromagnetic compatibility (EMC) - part 4-6: testing and measurement techniques -
immunity to conducted disturbances, induced by radio-frequency fields
EN61000-4-11 Electromagnetic compatibility (EMC) - testing and measurement techniques - voltage
dips, short interruptions and voltage variations immunity tests