ARRI MB-20 Quick Guide 02/2006, Page 9
Vertical Adjustment
The Swing-away Module is attached to either the Console for Lightweight Support or the Console for 235 Side
Bracket by two M4 screws. Between these is an adjuster for the vertical alignment of the matte box. To operate
this adjuster, use a 3mm hex wrench to loosen the two M4 screws slightly before using it to rotate the adjuster.
Once the desired alignment is achieved, tighten the two M4 screws.
Horizontal Adjustment
Before tightening the blue clamp knobs, the horizontal position of the matte box can be fine tuned by rotating
the two black horizontal adjusters (top one only shown). Once the desired alignment is achieved, lock the two
blue clamp knobs.
Basic Operation
M4 screws
Vertical adjuster
Black horizontal
adjuster
Blue clamp knob
