ARRI ICS-1, Instruction Manual

Page: 47 / 66

47
Camera Display
8. Indicators on the Camera Display
As soon as singleframe operation on the Singleframe
Hand Control is switched on (switch SF to ON), “SF” is
displayed in the lower line of the camera display.
In Mode 1 of the camera display (recognisable by the
horizontal black bar in the upper right-hand corner)
various information can be displayed. The following four
indications can be set:
• Total exposed film or take counter in meters or feet
depending on the setting (see Instruction Manual
ARRIFLEX 435), recognisable by the m/ft symbol in
the display.
• Shutter angle of the mirror shutter, recognisable by the
triangular symbol in the display.
• Framecounter, recognisable by the letters Fr in the lower
display line.
• Remaining interval time, recognisable by the colon
between hours and minutes in the upper display line.
8.1 Configuring Mode 1
of the Camera Display
• If the display is not in Mode 1 (recognisable by the
horizontal black bar in the upper right-hand corner),
change to Mode 1 by pressing the MODE key
➪
photo
several times.
• Press the SEL key
➪
photo several times to select the
desired indications.
• Press the SET key
➪
photo to confirm the selection.